Irish Drums & Percussion

Gibraltar Hardware

LP Replacement Parts & Hardware

Description: Designed for ALL instruments, including drums and EXCELLS with sax, toms, brass and percussion.  Clips on your instrument.  Great for Drums & Percussion. Outstanding frequency range.

The mic head can detach from the clip and can fit in small instrument holes, and works great with instruments such as the LP Udu drum.

Diameter of the front of mic head: 10.2 mm = 0.40 inch (13/32"); mic hole on the LP udus is about 12 mm.

Frequency Range: 50 - 15,000 Hz

Includes: AT8418 UniMount® clip, which permits accurate positioning and provides shock resistance while protecting the element; very flexible and sturdy; AT8538 power module

Includes: Carrying/storage pouch

Cable: 6' (1.8 m) cable permanently attached between microphone and power module; , 0.10" (2.6 mm) diameter, 2-conductor, shielded cable

Polar Pattern: Cardioid; cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source

Extended frequency response captures subtle nuances of the performance

Element: Fixed-charge back plate, permanently polarized condenser

Low Frequency Roll-Off: 80Hz, 18 dB/octave

Open Circuit Sensitivity: -45 dB (5.6 mV) re 1V at 1 Pa

Impedance: 250 ohms

Maximum Input Sound Level: 145 dB SPL

Phantom Power Requirements: 11-52V DC, 2 mA typical

Switch: Flat, roll-off

Output Connector (Power Module): Integral 3-pin XLRM-type

Excels in high-SPL applications and is> ideal for active stage performances

Reduces sound from sides and rear; improving isolation of the instrument for which the mic is intended for.

List Price: $259.00